Decal
Application Instructions
Supplies Needed
|
·
Squeegee (Credit Card/ID) ·
Application Fluid in Spray Bottle (Mixture of 1 teaspoon of
liquid soap in 1 liter of water) don't over soap ·
Kitchen paper towel |
|
Each
Decal Consists Of 3 Layers
|
·
Top layer (application tape) ·
Middle layer (decal) ·
Bottom layer (backing wax paper) |
Application Instructions for 6” and 12” decals
If you are confident you can line it up before sticking it you usually can do a dry install on small graphics (if not just go with the basics)
|
|
1)
Clean application surface thoroughly with application fluid. |
|
|
|
2)
Apply masking tape along the top of your decal and place on the surface
area creating a hinge. |
|
|
|
3)
Flip Decal up and pull backing paper off half way only and fold against
back of decal. |
|
|
|
4)
Bring decal down and still holding on to the folded part, gently
squeegee the decal onto the window until the half of the total area has
been installed on the window. |
|
|
|
5)
Now peel the rest of the backing paper off and carefully squeegee the
decal onto the window. |
|
|
6)
Your decal will now be secured onto your surface area. |
|
|
7)
Finally, gently remove application tape by pulling straight back,
leaving the decal on the surface. |
Application Instructions for 23” decals
|
1)
Clean application surface thoroughly with application fluid. |
|
|
2)
Place decal (without removing tape) on application area to visual the
exact final location of your decal. This will prevent any unwanted
positioning of final position. |
|
|
|
3)
Remove backing wax paper, exposing the adhesive side of the decal and
spray application fluid onto the adhesive side of the decal. |
|
|
4)
Use application fluid to spray the surface area where the sticker will
be installed on. Make sure the surface area is completely sprayed down. |
|
|
5)
Apply the adhesive side of the decal to the surface. Now you can adjust
and readjust the decal without damaging it. |
|
|
6)
Squeegee out the fluid and bubbles starting from the center and ending
at the edges. This will ensure that excess fluid will be removed. Repeat
this a few times until you remove most of the application fluid between
the decal and the surface. |
|
|
Do
not pull
up on the backing paper. This may cause the decal to lift up. |
7) Wait about 1/2 to 1 full hour depending on the outside temperature. If you do not want to wait you can use a hair dryer and go lightly over the decal. After the decal has dried gently remove application tape by pulling straight back, leaving the decal on the surface. If decal comes off with the application tape (Top Layer), re-apply decal with squeegee (Step 6), and wait about 1/2 hour before attempting to remove application tape again.
|
|